Easy way to make a hole in a leather belt at home. Most tool boxes nowadays will include a power drill.
Center the punch over the marking give it a few solid whacks with a mallet and you should be left with a perfectly round hole.
How to make a hole in a belt. Start by marking the spot where the hole will be located. How to Make a Hole in a Belt Method 1. Similar to the hammer and nail or awl.
As you can tell with some of the tutorials you need to work slowly especially if youre adjusting a. A drill and drill but can. In this video I show you how to make a hole in a belt with a drill bit.
Hammer and Nail or an Awl. Easing than punching a hole with a leather punch. These sharp steel tubes come in several sizes but typically youd want to use the 316 size to make holes on a belt for a standard belt buckle.
Ideally you need a leather punch which will cut a very clean hole. Use a nail or even a pen to poke through the tape. To make a seal get a nail polish that is clear and apply to that point.
How to Punch a Hole in a Belt Without a Leather Punch. Take the belt off and place it on a flat surface. Lay the belt flat on a piece of wood with the outside part of the belt facing up.
It is an easy process and works really well if you take your time with it. Move the sharp knife in a circular movement as you push it slowly. To create the hole take the nail and place it on the mark you made then take the your scrap piece of wood to hammer the nail through the belt.
Make a hole in any. Tips for Adding a New Hole to Your Belt 1. How to make a hole in a leather belt.
Keep your belt stretched firmly you can hold one side of the belt under you foot and the other side with one of your hand while the other hand is holding the pliers and point the nail to the spot you want to make a hole and push into the belt. Do this repeatedly until you get rid of the piece of leather. Making a hole in a leather belt is easy with the correct tools.
Mark this area by drawing a small dot that is parallel to the other belt holes. The first thing to do is to mark the exact place you need to make a hole on the leather belt. Thats right all you need is a hammer and nail to get the job done.
How to punch a hole in belt 8 s with pictures wikihow leather punch making holes the clean and easy way waist belt ruler hole maker. As how to site ManMade DIY demonstrates to create a hole template for your belt place a piece of painters tape along the belt over the hole. Simply hold it with pliers and heat its tip up for a minute or so on the stove fire.
Make sure to get the distance right by using a ruler. Whether youre using a power drill or a pocket knife always make sure the apparatus in your hand. If your goal is to get the belt to fit better then put it on first so that you can mark it on the spot where the belt tongue meets the front of your waist.
Source : pinterest.com